Fun-Filled Birthday Party Centerpiece

Supplies:

¼ pound each of Make’n Mold candy wafers in desired colors
Make’n Mold painter’s palette (5775)
Make’n Mold Party Lollipop candy mold (0225)
12 Make’n Mold 4½" lollipop sticks (5000)
2 - 6" x 1" styrofoam discs
2 - 8" x 1" styrofoam discs
2 - 10" x 1" styrofoam discs
2 colors/patterns of wrapping paper, 2½ yards total
Low temperature glue gun and glue sticks
4 yards corded ribbon, ¼" width
Pre-cut wooden birthday party pieces (balloon, hats, candles)
20 yards curling ribbon

Melt candy wafers in painter’s palette according to package instructions. Use the brush from painter’s palette to paint the details in each mold cavity with melted wafers. Chill 1-2 minutes between each color. Fill mold cavities with desired back color.

Insert lollipop sticks into stick channels of the mold so that 1" of the end of the stick is inserted into the melted wafers. Roll the sticks so that each stick is completely covered with melted wafers. Chill 10-15 minutes.

Glue each of the same size discs to one another to create a separate layer of the birthday cake. Wrap each layer in wrapping paper.

Glue layers on top of one another from largest to smallest. Glue corded ribbon around top and bottom of each layer’s outer edge.

Trace each pre-cut wooden party piece onto the back of the wrapping paper. Cut pieces out and attach to each matching wooden piece with spray adhesive. Paint the flame of each candle red. Dry 30 minutes. Glue wooden pieces to the centerpiece where desired. Drape curling ribbon around centerpiece.

Once candy pieces are finished, insert into bottom two layers of centerpiece.

Click here to purchase products used in this recipe: